Trolling Motor Installation
Bow-mount, transom-mount, and shallow water anchor installs done right. Proper wiring. Proper mounting. No shortcuts.
A trolling motor install is not just bolting a motor to the bow. Done right, it includes proper deck reinforcement, the correct wire gauge from battery to motor, an inline breaker, a quality plug, and a mount that won't loosen the first time you hit chop. Done wrong, you melt wires, void warranties, and end up paying us to fix someone else's work.
We install trolling motors and shallow water anchors for boats of every size — from kayaks to bay boats to pontoons.
What We Install
- Minn Kota bow-mount & transom
- MotorGuide Xi-series & Tour
- Garmin Force & Force Kraken
- Lowrance Ghost
- Power-Pole shallow water anchors
- Minn Kota Talon
- Quick Release Brackets
- Transducer mounting on trolling motor lower units
What's Included in a Proper Install
- Mount inspection & reinforcement — we check your deck and add backing if needed
- Correct wire gauge run — sized for the motor's amp draw and run length
- Inline circuit breaker — required protection, often skipped by DIY installs
- Quality marine plug — the cheap ones corrode within a season
- Battery selection guidance — 12V, 24V, or 36V; lead-acid vs. lithium
- Charging system check — we make sure your onboard charger is right for the new setup
- Water test & calibration — Spot Lock / Pinpoint / GPS Anchor calibrated before you leave
Common Install Mistakes We Fix
- Undersized wire causing voltage drop and motor performance issues
- No inline breaker — fire risk and warranty issue
- Loose mounting that vibrates apart in chop
- Improper battery wiring (parallel vs. series) for 24V/36V systems
- Onboard charger sized wrong for new battery bank
- Transducer mounting in the wrong spot causing interference
Frequently Asked Questions
How long does a trolling motor installation take?
A typical bow-mount install is a half to full day of work depending on the boat. We schedule installs in advance and most are completed the same day you drop off the boat.
Can you install a motor I bought online?
Yes. We install motors regardless of where they were purchased, as long as they are new or known-good condition.
Do I need to reinforce the deck for a new bow-mount?
Sometimes. Larger thrust motors (80–112 lb) put real load on the deck. If your boat has thin or rotted plywood, we recommend a reinforcement plate or backing — we can do that as part of the install.
What size trolling motor should I get for my boat?
Thrust is mostly about boat length and weight: rough rule is 5 lb of thrust per 100 lb of fully loaded boat weight. Shaft length depends on bow height to waterline. Call us with your boat info and we will help you spec the right setup before you buy.